User Manual
Table Of Contents
- 1. Before You Start...
- 2. Cooker Overview
- 3. Using the Glide-out Grill™
- 4. Cooking tips
- 5. Cooking Table
- 6. Cleaning your cooker
- 7. Troubleshooting
- 8. Service and Spares
- 9. Installation
- Positioning the Range
- When Fitting Between Kitchen Cabinets
- Moving the range
- Lowering the two rear rollers
- Completing the move
- Levelling
- Fitting the stability bracket or chain
- Conversion to Another Gas
- Gas Connection
- Natural Gas
- Propane
- Pressure Testing
- Electrical Connection
- Fixed Wiring
- Repositioning the range following connection
- 10. Final Fitting
- 11. Conversion to LP Gas
- 12. Servicing
- 13. Circuit Diagram
- 14. Technical Data
24
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
Location of range
The range may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
This appliance is designed for domestic cooking only. Use for
any other purpose could invalidate any warranty or liability
claim.
NOTE: An appliance for use on LPG must not be installed
in a room or internal space below ground level, e.g. in a
basement.
Conversion
This appliance is supplied set for G20 20 mbar Cat II
2H3+
.
A conversion kit for another gas is available for the range.
If the appliance is to be converted to another gas we
recommend that this is carried out before installation.
After converting the appliance, please attach the Gas
Conversion sticker over the appropriate area of the data
badge – this will identify the gas type for which the appliance
is now set.
You will need the following equipment to complete the
range installation satisfactorily:
• Stability bracket: If the range is to be supplied with gas
through a flexible hose, a stability bracket or chain must
be fitted. These are not supplied with the range but
are available at most builders’ merchants.
• Gas pressure tester/manometer.
• Flexible gas hose: Must be in accordance with the
relevant standards.
• Multimeter: For electrical checks.
You will also need the following tools:
1. Electric drill
2. Masonry drill bit (only required if tting the range on a
stone or concrete oor)
3. Wall plugs (only required if tting the range on a stone
or concrete oor)
4. Steel tape measure
5. Cross head screwdriver
6. Flat head screwdriver
7. Spirit level
8. Pencil
9. Adjustable spanner
10. Screws for tting stability bracket
11. 13 mm spanner or socket wrench
Checking the parts:
3 pan supports Wok cradle
ArtNo.000-0009 Wok ring, cast
Grill pan and trivet 2 Flat shelves with runners
Tall oven shelves and shelf supports Stability location bracket
ArtNo.000-0010 Tall oven shelves
Restraining chain & hook * Conduit box
ArtNo.020-0021 - Restraining
chain & hook
Stability bracket
9. Installation