User's Manual

INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
31
Alternative positions
for stability location
bracket
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability
bracket
Floor
Stability
location
bracket
Wall
Typical wall mounting
ArtNo.070-0014 - Stability bracket - Wall fitting
Cooker
Stability bracket
Floor
Stability
location
bracket
Typical oor mounting
Levelling
You are recommended to use a spirit level on a shelf in one of
the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
The front feet and rear rollers can be adjusted to level the
cooker.
To adjust the height of the rear of the cooker use a 13 mm
spanner or socket wrench to turn the adjusting nuts at the
front bottom corners of the cooker.
To set the front, turn the feet bases to raise or lower.
Fitting the Stability Bracket and
Chain
n
A stability bracket and chain MUST be tted when
the cooker is connected to a exible gas supply.
Unless properly installed, the cooker could be tipped by
leaning on the door. Injury might result from spilled hot
liquids or from the cooker itself.
n
IMPORTANT: The cooker must be set to the correct
height and levelled before the stability bracket is
installed.
Fitting a Stability Bracket
When tting a stability bracket ((Fig. 11.6) please refer to the
instructions supplied with the bracket for further details on
tting.
When tting a stability bracket (Fig. 11.7 and Fig. 11.8)
adjust the bracket to give the smallest practicable clearance
between the bracket and the engagement slot in the rear of
the cooker.
Fit the bracket so that it engages as far as possible over the
chassis of the cooker.
Fig. 11.6
Fig. 11.7
Fig. 11.8
Caution, possibility of tilting
Anti-tip restraints