User's Manual
Table Of Contents
- 1. Before You Start...
- 2. Cooker Overview
- The Hob
- Pan Detector,
- Residual Heat Indicator, H
- Child Lock, 
- Low Temperature Setting, L1/L2/L3
- Power Boost Setting, P
- Power Sharing Zones (Fig. 2.8)
- The Bridging-Zone Function, 
- Overheat Function
- The Glide-out Grill™ (Fig. 2.14)
- Bread Proving Drawer
- The Ovens
- Multifunction Oven Functions
- Operating the Ovens
- Accessories
- 3. Using the Glide-out Grill™
- 4. 3 Button clock
- 5. Cooking Tips
- 6. Cooking Table
- 7. Cleaning Your Cooker
- 8. Troubleshooting
- 9. Service and Spares
- 10. Installation
- Safety Requirements and Regulations
- Provision of Ventilation
- Location of Cooker
- Positioning the Cooker
- Moving the Cooker
- Lowering the Two Rear Rollers
- Completing the Move
- Fitting the Stability Bracket
- Repositioning the Cooker Following Connection
- Levelling
- Electrical Connection
- Connection in New Zealand
- Fixed Wiring
- Final Fitting and Checks
- Customer Care
- 11. Servicing
- 12. Circuit Diagram
- 13. Technical Data
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
39
Element xing screws
ArtNo.321-0005 Fan oven element
5.3 To Remove an Oven Inner Back
n
DISCONNECT FROM ELECTRICITY SUPPLY.
Open the door and remove the shelves. Remove the screws
and washers securing the inner back to the back of the oven
(Fig. 11.1). Carefully lift away the inner back. Reassemble in
reverse order making sure that the screws and washers are
fully tightened.
5.4 To Remove the Fan Oven Element
n
DISCONNECT FROM ELECTRICITY SUPPLY.
Remove the oven inner back (see 5.3). Remove the two
screws from the top of the element and the one from the
bottom of the element inside the oven (Fig. 11.2).
Lift the element out carefully, disconnecting the terminals
connected to the element (noting their positions).
If it is not possible to disconnect the leads in this way, pull the
cooker forward to gain access to the rear.
Remove the screws securing the electric cover to the back
sheet, remove the cover and disconnect the terminals from
the rear.
5.5 To Replace an Oven Fan
n
DISCONNECT FROM ELECTRICITY SUPPLY.
Pull the cooker forward to gain access to the rear. Remove
the screws securing the electric cover to the back sheet and
remove the cover.
Disconnect the three terminals connected to the fan noting
their position. Remove the oven inner back (see 5.3). Hold
the fan blade and remove the centre nut (left-hand thread)
two brass washers, fan blade and circlip. Unscrew the fan
retaining nuts and washers (three o each) and lift the
fan away from the rear of the cooker. Fit the new fan and
reassemble in reverse order.
Check the operation of the oven.
Fig. 11.1
Fig. 11.2