User's Manual
Table Of Contents
- U111318 - cover
- U111318-01 NEXUS STEAM OVEN 110 DUAL FUEL [AUS]
- 1. Before You Start...
- 2. Range Overview
- 3. Using the Glide-out Grill™
- 4. The Multifunction Oven
- 5. The Steam Cavity
- 6. Cleaning Your Cooker
- 7. Troubleshooting
- 8. Service and Spares
- 9. Installation
- Safety Requirements and Regulations
- Provision of Ventilation
- Location of Cooker
- Conversion
- Positioning the Cooker
- Moving the Cooker
- Lowering the Two Rear Rollers
- Completing the Move
- Levelling
- Repositioning the Cooker Following Connection
- Gas Connection
- Natural Gas
- Propane
- Pressure Testing
- Electrical Connection
- Connection in New Zealand
- Fixed Wiring
- Final Fittings and Checks
- Customer Care
- 10. Conversion to LP Gas
- 11. Servicing
- 12. Circuit Diagram
- 13. Technical Data
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have nished.
44
Conversion from Natural Gas
(1.0 kPa) to LPG X Propane
(2.54 kPa)
n
A suitably competent person must perform the
conversion. After conversion the installation must
comply with the relevant regulations and also the
local electricity supply company requirements. Read
the instructions before converting this appliance.
n
Failure to convert the appliance correctly could
invalidate any warranty or liability claims and lead
to prosecution.
n
When servicing or replacing gas-carrying
components disconnect from the gas supply before
starting operation. Check the appliance is gas sound
after completion.
n
DO NOT use reconditioned or unauthorised gas
controls.
n
Disconnect from the electricity and gas supply
before conversion.
n
Before electrical reconnection, check that the
appliance is electrically safe.
Hotplate
Injectors
Remove the burner caps and heads. Remove the old jets
(Fig. 10.1). Fit the new jets (see the ‘Technical Data’ section
at the back of this book for the correct jets). Reassemble in
reverse order.
Bypass Screw Adjustment
Pull o the control knobs and turn the bypass screw on each
control clockwise to the stop (Fig. 10.2). Ret the control
knobs.
10. Conversion to LP Gas
Fig. 10.1
Fig. 10.2
A
B
ArtNo.311-0010 Injectors
A – Jet, B – Jet