User Manual
Table Of Contents
- U111318 - cover
- U111318-01 NEXUS STEAM OVEN 110 DUAL FUEL [AUS]
- 1. Before You Start...
- 2. Range Overview
- 3. Using the Glide-out Grill™
- 4. The Multifunction Oven
- 5. The Steam Cavity
- 6. Cleaning Your Cooker
- 7. Troubleshooting
- 8. Service and Spares
- 9. Installation
- Safety Requirements and Regulations
- Provision of Ventilation
- Location of Cooker
- Conversion
- Positioning the Cooker
- Moving the Cooker
- Lowering the Two Rear Rollers
- Completing the Move
- Levelling
- Repositioning the Cooker Following Connection
- Gas Connection
- Natural Gas
- Propane
- Pressure Testing
- Electrical Connection
- Connection in New Zealand
- Fixed Wiring
- Final Fittings and Checks
- Customer Care
- 10. Conversion to LP Gas
- 11. Servicing
- 12. Circuit Diagram
- 13. Technical Data
WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
46
n
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS TURN OFF THE GAS SUPPLY
n
Check the appliance is gas sound after completion
of service. When checking for gas leaks do not use
washing up liquid – this can corrode. Use a product
specically manufactured for leak detection.
n
Do not use reconditioned or unauthorised gas
controls.
n
Disconnect from the electricity supply before
servicing, particularly before removing any of the
following: control panel, side panels, hotplate tray
or any electrical components or covers.
n
Before electrical reconnection, check that the
appliance is electrically safe.
1 Panels
1.1 To Remove the Control Panel
n
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull o all the control knobs and remove the xing screws
underneath the control panel.
The control panel will drop down slightly. It is held at the top
by two holes in the top edge, one at each end, that locate on
the tags on the inner panel. Lift the control panel clear of the
tags and pull forwards, taking care not to damage or strain
the wiring.
1.2 To Remove the Side Panels
n
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the control panel (see 1.1). Pull the cooker forward.
Remove the 4 retaining screws for each panel (1 at the front
base, 1 on the top and 2 at the rear).
Reassemble in the reverse order.
2 Hotplate
n
DISCONNECT FROM THE ELECTRICITY SUPPLY.
2.1 To Remove the Hotplate
Caution - The ceramic hob material is much more sensitive to
scratches on the underside than the top.
Take care not to touch or scratch the underside of the ceramic
as this will weaken the material and cause the top to shatter.
Remove the pan supports, hotplate burner caps and tops.
Remove the screws holding the hotplate burners to the
hotplate. Remove the screws holding the hotplate to the
chassis (Fig. 11.1).
Taking care not to damage the burner electrodes, carefully lift
the hotplate, from underneath disconnect the earth lead at
the right hand rear from the rear cross member and withdraw
the hotplate.
Reassemble in reverse order ensuring that the leads are
11. Servicing
Fig. 11.1