User Manual

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have nished.
37
6.6 To Adjust the Main Oven Door Catch Keep
Open the oven door, and slacken o the locknut at the
base of the keep (Fig. 8.9).
Screw in or out as required until the required t is
obtained. Retighten the locking nut.
6.7 To Replace the Tall Oven Door Outer Panel
Remove the oven door (see 6.2). Lay the door face down
on a suitable surface and remove the two screws from
the bottom edge of the door and the two screws from
the inside face of the door.
Remove the outer door panel. Remove the handle by
unscrewing the two screws. Unscrew the two cross-
headed screws holding the door handle xing bracket
to the door panel. Fit the door handle bracket and door
handle to the new panel.
Fit the panel to the door and reassemble in the reverse
order.
6.8 To Replace the Tall oven Magnetic Latch
Remove the control panel (see 1.1). Remove the plinth
and the central vertical cover (5 screws). Prise the
retaining clip o the magnet unit.
Fit the new unit and retaining clip, and reassemble in
reverse order. Check that the door operates correctly.
6.9 To Replace an Oven Door Seal
Open the oven door. The seal has small hooks that hold
it in place by locating into holes in the rear door face
on the main oven and oven front face on tall oven. At
the corner, pull the seal diagonally away from the door
centre until the hook is released (Fig. 8.10). Proceed to
the next hook and release it in a similar way, and so on.
You can use force if the hooks are sti, as the old seal
will be discarded. Carefully lift away the inner back.
Reassemble in reverse order making sure that the four
screws and washers are fully tightened.
ArtNo.320-0005 Oven door rubber seal
Fig. 8.10