User's Manual
Table Of Contents
- 1. Before You Start...
- 2. Cooker Overview
- 3. Using the Glide-out Grill™
- 4. 3 Button clock
- 5. Cooking tips
- 6. Cooking Table
- 7. Cleaning your cooker
- 8. Troubleshooting
- 9. Service and Spares
- Safety Requirements and Regulations
- Provision of Ventilation
- Location of Cooker
- Positioning the Cooker
- Moving the Cooker
- Fitting the Stability Bracket
- Repositioning the Cooker Following Connection
- Levelling the Cooker
- Electrical Connection
- Connection in New Zealand
- Fixed Wiring
- Final Checks
- Final Fitting
- Customer Care
- 10. Servicing
- 11. Circuit Diagrams
- 12. Technical Data
35
WARNING! Refer to Before You Start... chapter.
Check the appliance is electrically safe and gas sound when you have nished.
Final Checks
Hob Check
Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Set the clock as described earlier, and then turn on the ovens.
Check the oven fans start to turn and that the ovens heat up.
Final Fitting
Fitting the Plinth
Remove the 3 screws along the front bottom edge of the
cooker. Position the plinth, replace and tighten 2 of the xing
screws (Fig. 9.17). The third can be discarded.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
ArtNo.350-0012 - Securing the plinth
Fig. 9.17
x 2 positions