Installation and Operation Guide

INSTALLATION

Check the appliance is electrically safe and gas sound when you have nished.

ArtNo.3 0-0012 - Securing the plinth

Fixed Wiring

For connection to xed wiring, i.e. exible conduit, remove

the electrical terminal cover on the back panel.

Fix the conduit-to-conduit mounting bracket onto the rear

cover with screws (Fig. 7.13). Connect the mains cable to the

correct terminals for your electrical supply type (Fig. 7.10 and

Fig. 7.12). Check that the links are correctly tted and that

the terminal screws are tight.

Replace the electric terminal cover; make sure that the

conduit is clear of the bottom ange.

Final Checks

Note: The clock must be set before the ovens will work. See

‘The Clock’ section for instructions on setting the time of day.

Hotplate Check

Check each burner in turn. There is a Flame Supervision

Device (FSD) that stops the ow of gas to the burner if the

ame goes out. For each burner, turn the control knob to the

solid ame symbol. Press in the control knob. This lets gas

through to the burner. Keep holding the knob pressed in and

press the igniter button or light with a match. Keep holding

the control knob pressed in for about 10 seconds.

If, when you let go of the control knob the burner goes out,

the safety device has not held in. Wait one minute then try

again this time holding the control pressed in for slightly

longer.

Oven Check

Turn on the oven and check that it starts to heat up. Check

that the oven lights are working.

Note: The oven light bulb is not included in the guarantee.

Turn o the oven.

Fitting the Plinth

Loosen the three screws along the front bottom edge of the

cooker. Hook the central keyhole over the central screw. Twist

and t each end keyhole over their respective screws. Tighten

the xing screws (Fig. 7.14).

Customer Care

Installer: Please complete your details in this guide, inform

the user how to operate the cooker and hand over the

instructions.

Thank you.

Fig. 7.14