User's Manual

19
A
B
C
D
A – inner burner cap, B – outer burner cap,
C – burner head, D – wok burner base
Wok Burner
When reassembling the wok burner (Fig. 6.2) turn over the
large base ring and nd the ‘D’ shaped area (Fig. 6.3). Turn
the head until the ‘D’ matches the one on the burner base.
Flip the burner over once again and place it on the burner
base.
Check the burner slots are not blocked. If a blockage occurs,
remove stubborn particles using a toothbrush (Fig. 6.4).
Now t the two burner caps, making sure that they are seated
properly.
Check the burner ports are not blocked. If a blockage occurs,
remove stubborn particles using a piece of fuse wire.
Griddle
Always clean the griddle after use. Allow it to cool completely
before removing. Immerse the griddle plate in hot soapy
water. Use a soft cloth or, for stubborn stains, a nylon washing
up brush.
Wok Cradle
Recommended cleaning materials are hot soapy water, a
moistened soap pad, cream cleaner or nylon scourer.
Control panel and oven doors
The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth. The
oven doors should only be cleaned with a soft cloth wrung
out in clean hot soapy water.
Removing the oven door outer panel
The outer door panel can be removed so that the inside of
the glass can be cleaned. Undo the 4 screws (2 each side) in
the door (Fig. 6.5).
Open the door slightly and, using the handle, carefully lift the
door outer upwards.
Ret in reverse.
ArtNo.272-0015 - 90DF - Pro+ - Removing the outer door panel
Fig. 6.2
Fig. 6.3
Fig. 6.4
Fig. 6.5