User's Manual
Table Of Contents
- U111316 - cover [Aus]
- U111316-01 PROFESSIONAL+ FXP 90 DUAL FUEL [AUS]
- 1. Before You Start...
- 2. Overview
- 3. 6 Button clock
- 4. Cooking tips
- 5. Cooking Table
- 6. Cleaning your cooker
- 7. Troubleshooting
- 8. Service and Spares
- 9. Installation
- Safety Requirements and Regulations
- Provision of Ventilation
- Location of Cooker
- Conversion
- Positioning the Cooker
- Moving the Cooker
- Removing the Oven Door
- Lowering the Two Rear Rollers
- Completing the Move
- Levelling
- Fitting the Stability Bracket and Chain
- Fitting a Stability Bracket
- Fitting the Restraining Chain
- Gas Connection
- Pressure Testing
- Electrical Connection
- Fixed Wiring
- Final Checks
- Final Fitting
- Customer Care
- Fitting the drawer
- Removing the drawer
- 10. Conversion to propane gas
- 11. Servicing
- 12. Circuit Diagram
- 13. Technical Data
- Blank Page
- Blank Page
- Blank Page
- Blank Page
INSTALLATION
Check the appliance is electrically safe and gas sound when you have nished.
33
solid ame symbol. Press in the control knob. This lets gas
through to the burner. Keep holding the knob pressed in and
press the igniter button or light with a match. Keep holding
the control knob pressed in for about 10 seconds.
If, when you let go of the control knob the burner goes out,
the safety device has not held in. Wait one minute then try
again this time holding the control pressed in for slightly
longer.
Oven Check
Turn on the oven and check that it starts to heat up. Check
that the oven lights are working.
NOTE: The oven light bulb is not included in the guarantee.
Turn o the oven.
Final Fitting
Fitting the Plinth
Remove the 3 screws for the plinth mounts along the front
bottom edge of the range (Fig. 9.14). Fasten the plinth using
these screws.
Refitting the Oven Door
To ret the door, slide the hinges back into their slots. Rotate
the locking ‘U’ clips back to t onto the hinges.
Customer Care
INSTALLER: Please complete your details in this guide,
inform the user how to operate the cooker and hand over the
instructions.
ArtNo.281-0026 - Front plinth
Fig. 9.14