User's Manual

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have nished.
39
Catalytic lter cover
Bracket
Phial retaining
clamp
Protection & primary phials
Pyrolytic phial
3. To Replace the Ignition Spark Generator
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the hotplate (see 1. To Remove the Hotplate).
Disconnect all the leads from the generator, taking note of
their positions. Unclip the generator from the cooker.
Fit the new generator and reconnect the leads. Check for
correct ignition.
4. Ovens
1. To Change an Oven Thermostat
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Situated at the back of the oven, behind the right-hand upper
elements, are the primary and protection thermostats phials.
One the right-hand side of the same element is the pyrolytic
phial (Fig. 11.5).
To Change the Primary Thermostat
Remove the control panel (see 1. To Remove the Control ) and
hotplate (see 1. To Remove the Hotplate).
Remove the oven shelves, shelf supports and divider.
Undo the cooker rear cover screws and remove the covers.
Undo the screw holding the phial retaining clamp to the
bracket. Undo the 2screws securing the catalytic lter cover
(Fig. 11.6).
Track the route of the thermostat capillary from the rear of
the control on the fascia to where it disappears into the oven.
By moving the capillary it will become obvious which of the
2 phials in the oven it is connected to. The phial can then be
removed.
Feed the thermostat capillary out and clear of the oven,
noting the routing.
Remove the 2 screws xing the thermostat to the inner
control panel and disconnect the wiring from the thermostat.
Fit the replacement in reverse order.
To Change the Protection Thermostat
Follow the same procedure as above except that the control
is situated on the rear cover.
Fit the replacement in reverse order.
To Change the Pyrolytic Thermostat
Remove the control panel (see 1. To Remove the Control ) and
hotplate (see 1. To Remove the Hotplate).
Remove the oven shelves, shelf supports and divider.
Undo the cooker rear cover screws and remove the covers.
Remove the 2 screws holding the small retaining plate on the
back of the cooker and remove the plate.
Remove the pyrolytic phial.
Fit the replacement in reverse order.
Fig. 11.5
Fig. 11.6