Installation Guide

ManualsBrandsFalcon ManualsHardwareT Series Single Cylinder Keyed Entry Grade 1 Dane Classroom Door Lever Set with Small Format Interchangeable Core

T-Series Service Manual

STEP 1

Fold template on line indicated.

Place on HIGH EDGE of door bevel.

Position centerline of template on heightline (suggested

height is 38" (965mm) from floor).

A. Locate and mark center for 267" (54mm) hole.

B. Locate and mark positions for notches.

Caution: Notches must be horizontal.

C. Locate and mark center for two (2)7RF" (8mm)

thru-bolt holes.

D. Locate and mark center for 1" (25mm) latch bolt hole

in door edge.

Note: If steel frames are used, the latch centerline must

be in line with the center of the strike preparation.

Hint: For retrofitting of existing 267" (54mm) holes, fold template in half to locate position for the two (2) 7RF" (8mm) holes.

MARK DOOR

INSTALLATION INSTRUCTIONS FOR INSTALLING

T-SERIES

EXTRA HEAVY DUTY LEVER LOCKSET

IMPORTANT: THIS LOCK IS NON-HANDED. LOCK IS FACTORY PACKED PREADJUSTED FOR 17N" (45mm)

THICK DOORS. TO ADJUST LOCK FOR OTHER DOOR THICKNESS, SEE STEP 8, 9 & 10. SPACERS MUST

BE USED FOR DOORS THINNER THAN 17N" (45mm) THICK. FOR FUNCTIONS

T341, T351, T371, T381, T391, T561

& T571

SEE STEPS 17 (STANDARD CYLINDER) OR 18 (IC CORE) FOR TIMING INSTRUCTIONS.

Set Screw

67N-20 x 67N"

Mounting Screws

#10-32 x 1"

Outer Trim Assembly

Interchangeable Core Cylinder

Inner Lever

Rose

Inner Trim Assembly

Flange Nut

Inner Mounting Plate

*Spacer

Spacer required for all

doors under 17N" thick.

Attaching Screws

#8 Combination

*Spacer

Spacer required for all

door under 17N" thick.

Latch Assembly

Chassis Assembly

Outer Trim Assembly

Standard Cylinder

LEFT HAND REVERSE SHOWN

INSIDE

OUTSIDE

LEFT HAND

LEFT HAND REVERSE

RIGHT HAND

RIGHT HAND REVERSE

DOOR HANDS DETERMINED FROM OUTSIDE

OUTSIDE

INSIDE

High Edge Of Bevel Door

D) Mark Latch Hole

A) Mark 267" Hole

C) Mark Thru-Bolt Holes

TEMPLATE FOR

INSTALLING

T–SERIES LEVER

LOCKS

LATCH

MARK CENTER FOR

5/16"(8mm) HOLES

USING DRILL FIXTURE

030736-000-50 IS

RECOMMENDED TO

ENSURE PROPER

ALIGNMENT OF

THRU-BOLT

HOLES.

2 3/4"(70mm) BACKSET

MARK CENTER FOR

2 1/8"(54mm) HOLE

IMPORTANT:

CHECK LOCK FOR PROPER

BACKSET BEFORE DRILLING

5/32"(4mm)

x1/8"(3mm) DEEP

2"(51mm) DR

"(57mm) DR

"(45mm) DR

DOOR CENTERING ADJUSTMENT

FOLD HERE &

PLACE ON HIGH

EDGE OF DOOR

MARK CENTERLINE OF LATCH

FOR CORRECT DOOR THICKNESS.

DRILL 1"(25mm) DIA HOLE.

HIGH EDGE

1 3/4"

(45mm)

2"(51mm)

2 1/4"(57mm)

B) Mark Notches

03079400070