Installation Guide

ManualsBrandsFalcon ManualsHardwareT Series Single Cylinder Keyed Entry Grade 1 Dane Classroom Door Lever Set with Small Format Interchangeable Core

T-Series Service Manual

STEP 2

BORE HOLES: INSTALL LATCH

A. Bore a 267" (54mm) hole and two (2) 7RF" (8mm) holes

from both sides of door to avoid splintering wood.

B. Bore a 1" (25mm) hole into door edge. Using latch faceplate

as pattern, trace outline and mortise door edge so latch is flush

with door. If 7N projection latch is to be installed see Step 20.

Note: For wood jambs, close door and using a strike-locating tool

or other pointed object mark position of hole in jamb. Open door

and drill 1" (25mm) hole in jamb minimum 7N" (19mm) deep.

C. File two (2) 7;P" (4mm) x 7;P" (4mm) x 67" (3mm) deep notches

into both sides of door.

D. Insert latch unit in door, making certain that latch bolt bevel faces

direction of closing door. Attach with two #8 combination screws

provided.

Note: Use of a drill guide is recommended to ensure

straight and level holes.

IF USING THE FALCON OPTIONAL DRILL GUIDE

Install Drill Guide (030736-000-70) into door. Make certain correct backset

locators are even with door edge. Drill two (2) 7RF" (8mm) holes from both

sides to center.

Note: Drill guide replacement is recommended after 10 door preparations.

When drilling through door, be careful not to damage door finish.

STEP 3

INSTALL CHASSIS AND OUTER TRIM ASSEMBLY

Note: For ease of installation, lock should be in

the unlocked position.

Slide chassis assembly into door from outside

making sure that lock housing engages latch

prongs. Retractor must also engage latch tail.

Important: Chassis assembly must be positioned

in center of door for proper operation.

STEP 4

INSTALL INNER MOUNTING PLATE

A. Place inner mounting plate onto chassis assembly

making sure that plate tabs engage horizontal

notches in door.

B. Position flanged nut over chassis assembly and

tighten securely with hex wrench provided.

Lock Housing

Latch Prong

Latch Tail

Retractor

Latch Case

Chassis Assembly

Outside of Door

Notches

Tab

Flanged Nut

Black Hex Wrench Chassis Assembly

Tab

Inner Mounting Plate

A) 5/16" (8mm)

Thru hole

C) File Notches

B) 1" (25mm) Hole

5/32"

Latch

Bolt Bevel

Latch Unit

A) 2-1/8" (54mm)

Thru hole

A) 5/16" (8mm)

Thru hole

Use faceplate as pattern for mortise.

Backset

Locator