Installation Guide

T-Series Service Manual
55
FOLD HERE &
PLACE ON HIGH
TEMPLATE FOR
INSTALLING
T–SERIES LEVER
LOCKS
MARK CENTERLINE OF LATCH
FOR CORRECT DOOR
THICKNESS.
HIGH EDGE
LATCH
MARK CENTER FOR
5/16"(8mm) HOLES
USING DRILL
FIXTURE
030736-000-50 IS
RECOM-
MENDED TO
ENSURE
PROPER
ALIGNMENT
2 3/4"(70mm) BACKSET
MARK CENTER FOR
2 1/8"(54mm) HOLE
IMPORTANT:
CHECK LOCK FOR PROPER
BACKSET BEFORE DRILLING
1 3/4"
(45mm)
2"(51mm)
2 1/4"(57mm)
5/32"(4mm)
5/32"(4mm)
x1/8"(3mm) DEEP
2"(51mm) DR
2 1/4"(57mm) DR
1 3/4"(45mm) DR
DOOR CENTERING ADJUSTMENT
STEP 9
ADJUST LOCK FOR DOOR THICKNESS
Lock is factory packed preadjusted for 17N" (45mm) doors unless
ordered special.
A. Place template provided against retractor housing to find
marking for door thickness.
B. If adjustment is necessary, use hex wrench provided
and rotate flanged nut counterclockwise to adjust.
Again, use template markings to measure adjustment
before installing lock on door.
Hint: Three full turns of nut equals (=) 67" (3mm) adjustment.
C. Pinch button mount legs together and
move cap to desired position.
STEP 10
INSTALLING SPACER FOR DOORS THINNER
THAN 17N" (45mm)
A. Remove flanged nut with blakc hex wrench
pro-vided along with outer mounting plate.
B. Place on spacer over outer chassis spindle
as shown.
C. Re-install outer mounting plate and flanged nut.
Using adjusting gage provided adjust flanged nut
for proper door thickness as shown.
D. See Step 4 for chassis installation.
E. Place second spacer over inner chassis spindle
before installing inner mounting plate and
flanged nut. Continue at Step 5.
STEP 11
TO REMOVE ALL LEVERS WITH INTERCHANGEABLE CORE CYLINDERS
A. Insert control key into core and rotate 15 degrees clockwise.
Pull key to remove core.
B. Insert screwdriver into Figure "8" core hole and into lever
retainer.
C. Depress retainer and slide lever off spindle.
TO RE-INSTALL LEVER
D. Slide lever over spindle and push on over retainer.
E. Pull on lever to be sure retainer engaged lever.
F. Re-install core with tailpiece pushed into core.
STEP 12
IC CORE AND TAILPIECE
Be certain to use correct tailpiece with core.
Six pin cores should only use the "6P" tailpiece.
Seven pin cores should only use the "7P" tailpiece.
Chassis Assembly
Button Mount Legs
Cap
267N"
(57mm)
2"
(51mm)
17N"
(45mm)
Flanged Nut
Black Hex Wrench
Inner Mounting Plate
Flanged Nut
Gage
Spacer
Outer Mounting Plate
Spacer
Chassis Assembly
Flanged Nut
Spacer
Outer Mounting Plate
Push
Retainer
Control Key
6 Pin Core
7 Pin Core
DOOR CENTERING
ADJUSTMENT GAGE
NT FALCON T-SERIES LEVER
LOCKS FOR DOORS LESS THAN
1 3/4 (45mm) THICK
NT FALCON LOCK
P/N 030793-001-70
PRINTED IN U.S.A.
Outside
Inside
FALCON
FALCON
1 3/4 (45mm) 1 1/4 (32mm) 1 1/2 (38mm)