Installation Guide

T-Series Service Manual
57
STEP 17
FOR THE FOLLOWING FUNCTIONS: T341, T351, T371, T381, T391, T561, T571
A. If the cylinder and handle are installed, refer to step 13 for lever removal
instructions.
B. Using a thin flat screw driver, turn the action bar slot clockwise
(cw) until it stops at about 2:00.
C. Then turn the action bar counterclockwise (ccw) to the 9:00
position. NOTE: No physical stop is at this location.
D. With the key out, install standard cylinder into the spindle.
E. Refer to step 13 for lever installation instructions.
F. Operate key to test for proper operation.
TIMING INSTRUCTIONS FOR STANDARD CYLINDER LOCKS
STEP 18 TIMING INSTRUCTIONS FOR IC CORE LOCKS
STEP 19 TAILPIECE INSTALLATION INSTRUCTIONS FOR T381 FUNCTION
STEP 20
A. Determine the hand of the door.
B. On the side closest to the door stop, remove shaded area as shown.
Use a standard rotary file 7" diameter maximum.
C. Try latch for fit and function.
D. Secure latch with two (2) #8-32 machine screws provided.
INSTALLATION INSTRUCTIONS FOR OPTIONAL 7N PROJECTION LATCH
FOR THE FOLLOWING FUNCTIONS: T341, T351, T371, T381, T391, T561, T571
A. If the core is installed, refer to step 11 for IC core
removal instructions.
B. Using a thin flat screw driver, turn the action bar slot clockwise
(cw) until it stops at about 11:00.
C. Then turn the action bar counterclockwise (ccw) to the 7:00
position. NOTE: There is NO physical stop is at this location.
D. Using the control key, insert IC core into the lever and spindle.
E. Remove control key.
F. Operate key to test for proper operation.
SEE STEP 14 FOR
STANDARD CYLINDER
TAILPIECE
INSTALLATION
SEE STEP 12 FOR
IC CORE TAILPIECE
INSTALLATION
RH Shown
Action
bar
slot
Door
edge
RH Shown
Action
bar
slot
Door
edge
LONG TAILPIECE
SHORT TAILPIECE
OUTER STANDARD CYLINDER ASSEMBLY
INNER STANDARD CYLINDER ASSEMBLY
CLUTCH
ON
OUTSIDE
LONG TAILPIECE
SHORT TAILPIECE
OUTER IC CORE ASSEMBLY
INNER IC CORE ASSEMBLY
Door stop
on this side
1"
MIN
REF
167RF" MIN REF