Installation Sheet

INSTRUCTIONS FOR
REMOVAL OF AND
REASSEMBLY OF
CYLINDER KNOB
TO REMOVE CYLINDER KNOB
HOW TO
INSTALL
S SERIES
AND
X SERIES
FALCON
LOCKS
HOW TO
INSTALL
S SERIES
AND
X SERIES
FALCON
LOCKS
Cylinder knob should be installed as shown.
(key notches up)
If necessary to change hand of lock
so that cylinder will be right side up,
use the following instructions:
Assembly not installed in door:
Rotate key ¹⁄₄ turn clockwise,
depress knob catch and pull off
knob. Rotate housing 180° and
reinstall cylinder knob.
Assembly installed in door: Rotate
key ¹⁄₄ turn clockwise, depress
knob catch and pull off knob.
Rotate knob 180° and reinstall
cylinder knob.
With key in cylinder, align hole in knob
cap with knob catch and slip knob over
spindle up to knob catch.
KNOB CATCH
KNOB CATCH
With knob against knob catch, and
cylinder tailpiece engaged with key
spindle, hold knob, rotate key ¹⁄₄ turn
clockwise. Depress knob catch and
push knob until catch engages slot
in knob.
TO INSTALL CYLINDER KNOB
STEP ONE STEP TWO
TEMPLATE FOR S AND X SERIES
RECOMMENDED TEMPLATE INSTRUCTIONS MUST BE FOLLOWED TO ASSURE PROPER FUNCTIONING.
DISTANCE
FROM EDGE
OF DOOR
(BACKSET)
5"
(127 mm)
2 ³⁄₄"
(70 mm)
FOLD ALONG EDGE OF DOOR
SECOND BORE LATCH HOLE IN CENTER OF DOOR PARALLEL TO SIDES. 1” (25 mm) FOR 2³⁄₄” OR LONGER BACKSET
CENTER FOR 1³⁄₈”
(35 mm)
DOORS
CENTER FOR 1³⁄₄”
(44 mm)
DOORS
FIRST BORE 2¹⁄₈” (54 mm) HOLE AT CORRECT BACKSET AND ¹⁄₈” (3.2 mm)
CLEARANCE HOLES FOR ROSE INSERT POINTS
LITHO IN U.S.A.
¹⁄₈” DIA (3.2 mm)
2 HOLES ¹⁄₈” DEEP
BOTH SIDES OF DOOR
© Allegion 2014
Printed in U.S.A.
002290-000-70 Rev. 10/14-d