Operation Manual

To order new charcoal ﬁ lters contact the distributor/retailer.

VALID ONLY FOR ITALY: download the appropriate order form from: www.

falmec.com (access the assistance drop-down menu).

LIGHTING ASSEMBLY AND REPLACEMENT

FLUORESCENT TUBE

(Section reserved for qualified installers)

Fluorescent tube replacement:

a) Disconnect the appliance from the mains.

b) Remove the steel panel and the metal filters (see H 1). Undo the 2+2

knurled fixing studs in the steel support.

c) Remove the neon tube by rotating it by 90° and replace it with an identical

one (13W tube T5).

d) Repeat point B in reverse.

e) Reconnect the appliance to the mains

MAINTENANCE AND CLEANING

Constant maintenance ensures the correct operation and efficiency of the ap-

pliance over time. Special attention should be paid to the metal grease-trap-

ping filters and the charcoal filters. Frequent cleaning of the filters and their

supports will ensure that fats and grease do not accumulate on the range

hood, with the consequent risk of fire.

1. METAL GREASE-TRAPPING FILTERS

These trap the fat and grease particles suspended in the air, and therefore

should be washed every month in hot water and detergent, without bend-

ing them. Wait until they are completely dry before repositioning them.

To remove and replace these filters, see the instructions in point H1. This

operation should be performed at regular intervals.

2. CHARCOAL FILTERS

These trap the odours present in the stream of air that passes through

them. The air is purified by passing a number of times through the filters

and being recirculated into the kitchen. The charcoal filters cannot be

cleaned, and should be replaced on average every 3-4 months (according

to use). To replace the charcoal filters, see the instructions in point H2.