User Manual

PART 1: HOOD INSTALLATION GUIDE - INTEGRATED HOODS - REMOTE MOTOR
INTEGRATED HOOD
Models include MILANO F3ML60S1, F3ML90S1, F3MLD90S1, F3MLD12S1 and GENOVAF3GV12S1
STEP 1:
To install into your overhead cupboard, several holes may need to be cut into shelves to enable the ducting to exit the cavity.
Ensure the hood is mounted as close to the centre of the cooking surface as possible.
NOTE:
The height of the underside of the hood body must be a minimum of 600 mm above an electric cooktop & 650mm above a
gas cooktop and a maximum height of 1200 mm. If the instructions of the hob specify a greater distance than the minimum
detailed, this shall be the minimum height for installation. Building codes that stipulate a minimum dimension may vary from
state to state, please check with your local council prior to installation.
GENOVA F3GV12S1 model only - The height of the underside of the hood body must be a minimum of 1200 mm above a BBQ.
STEP 2:
If a shelf is fitted within the cupboard cut out a central 205 mm hole in the shelf for ducting, matching the holes position to that
of the outlet on top of the hood. Additional holes might need to be cut to feed the duct out to the roof cavity.
STEP 3:
Remove the screws from within the main body of the rangehood along the back above the grease trap, on the left and right
side . Once the screws are removed, the main body of the rangehood will separate away from stainless steel fascia.
STEP 4:
The returns on the main body are now exposed. These are used to fix the main body on to the cabinetry. Place the hood in the
cabinet in the level position ensuring that the controls and display will be visible when standing in front of the unit. Using the
pre-drilled mounting holes, screw the hood into position.
STEP 5:
Once the main body is secure into the cabinetry the stainless steel fascia can then be slid inside the main body.
The fascia will cover the screws that have fixed the main body into the cabinetry. Place the screws back into place which
were removed in step 3.
WARNING
DIMENSIONS ARE ACCURATE AT THE TIME OF PRINTING, PR KITCHEN & WASHROOM
SYSTEMS PTY LTD RESERVES THE RIGHT TO CHANGE SPECIFICATIONS WITHOUT NOTICE.
FOR BUILDING PURPOSES THE UNIT SHOULD BE PROVIDED TO THE CABINET MAKER /
BUILDER / KITCHEN DESIGNER FOR EXACT MEASUREMENTS.