Specifications

15
‘ + ‘ Key
If the motor is turned off, pressing the ‘+’ key will activate the motor at 1° (1st)
speed. If the motor is operating, pressing the ‘+’ key will increase motor speed up
to the maximum.
Timer Key
If the motor is active, pressing the timer key will activate/deactivate the timer
function
Code Change
(only in case of
malfunction)
Press the “Luce” (Light) key together with the “Timer” key of the remote control
until the blue LED begins to slowly flash. If the “-” key of the remote control
is pressed within 5 seconds, the new code will be generated and memorised.
Memorisation is confirmed by 3 brief flashes of the LED.
To return to the default code, apply pressure on the “-” key together with the “+”
key for over 5 seconds. Memorisation of the default code will be signalled with 3
brief flashes of the LED.
Each time that a new code is generated or that the default code is set in the
remote control, it is necessary to also carry out the previously described Remote
Binding (Light Key of the pushbutton) procedure.
FILTERS REMOVING AND REPLACING’S INSTRUCTIONS
H
1. METAL FILTERS
To remove the metal filter, open the door, following the procedure indicated in section G
(door opening button 1). This way, the filters can be removed by acting on the appropriate
handle.
2. CARBON FILTERS
Remove the metal filters as indicated in section H1. This way the carbon filters can be acces-
sed and be removed easily.
ONLY FOR ITALY: Download the filter order module from the website:
www.falmec.com (access the drop-down assistance menu).
LIGHTING ASSEMBLY AND REPLACEMENT
I
The range hood is equipped with high efficiency, low consumption LED strips with extremely
long duration under normal use conditions.
MAINTENANCE AND CLEANING
L
Constant maintenance ensures the correct operation and efficiency of the appliance over
time. Special attention should be paid to the metal grease-trapping filters and the charcoal
filters. Frequent cleaning of the filters and their supports will ensure that fats and grease do
not accumulate on the range hood, with the consequent risk of fire.
1. METAL GREASE-TRAPPING FILTERS
These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CHARCOAL FILTERS
These trap the odours present in the stream of air that passes through them. The air is
purified by passing a number of times through the filters and being recirculated into the
kitchen. The charcoal filters cannot be cleaned, and should be replaced on average every
English