Specifications

21
- the yellow-green wire must be used for the earth,
- the blue/white wire must be used for the neutral,
- the brown/black wire must be used for the phase; the cable must not come into contact with
hot parts (over 70°C).
- fit a plug that is suitable for the load to the power cable, and connect it to a suitable power
outlet.
For appliances that come supplied with cable and plug please ensure they are plugged into a
circuit suitable for this appliance.
Please refer to a qualifed person. (See technical specifications in point B).
The manufacturer declines all liability if the safety standards are not observed.
E
RANGE HOOD WITH EXTERNAL EXHAUST (ex-
tractor hood)
In this version, the kitchen fumes and vapours are conveyed to the outside through an exhaust
pipe.
The exhaust conveyor protruding on the upper part of the hood must be connected to a pipe
carrying the fumes and vapours into an external output.
This version does not require the use of charcoal fi lters supplied with hoods.
When the kitchen hood is used together with other appliances using gas or other fuels, the
room must be suffi ciently ventilation according to current standards.
When used in Germany:
When a range hood is simultaneously in operation with appliances supplied with energy
other than electricity, the negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar).
F
RECIRCULATING HOOD (filtering system)
In this model, air passes through charcoal fi lters for purifi cation and is then re-emitted into the
kitchen environment. For the installation of charcoal fi lters, please refer to section H2.
For maximum efficiency, the third speed should be used when there are strong odours or a lot
of steam, the second speed in normal conditions, and the first speed for keeping the air clean
with minimum energy consumption. The range hood should be switched on when starting to
cook, and left on until the odours disappear.
G
OPERATION
ELECTRONIC CONTROL PANEL
Light pushbutton
• ON: light on (the pushbutton is lit);
• OFF: light off;
Pushbutton -
Press to reduce motor speed
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and
the timer LEDs).
Pushbutton +
Press to increase motor speed
Speed 1, 2 and 3 are indicated by the number of LEDs that light up (excluding the light and
the timer LEDs).
English