Specifications

24
WARRANTY
M
The new equipment is covered by warranty. The warranty conditions are provided by the dis-
tributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting from printing or
transcription errors. The manufacturer reserves the right to modify its products as it consid-
ers necessary or in the interests of the user, without compromising their essential safety and
operating characteristics.
N
MOUNTING INSTRUCTIONS FOR POLAR ISOLA
HOOD
WARNING: Failure to install the screws or fixing device in accordance with these instructions
may result in electrical hazards.
N1
INSTALLATION INSTRUCTIONS FOR POLAR HOODS WITH GLASS
PREDISPOSITION
ISLAND HOOD
Fig. 1-2
- Remove the fastening screws between the extension and trellis (only for transport).
- Fasten the top trellis (C) to the ceiling using the 6 Fischer anchors, ø 8, and the screws pro-
vided (V1).
Fig. 3-4
- Locate the desired height between the hood and hob (see sect. C).
- Fasten the lower three-piece unit (chimney + extension + trellis, B+D+G) to the upper trellis
(C) using the 6 self-tapping screws (V2), making the lower trellis slide (G) inside the upper
trellis (C).
- For the exhaust version, locate the optimal height of the fumes exhaust pipe, and connect.
For the filter version, the upper extension slots must remain free to allow the air purified by
the carbon filters to be exhausted.
- Make electrical connections only after disconnecting the power supply.
Fig. 5
- Slide the extension (D) upwards under the top flange of the trellis. Next, turn it clockwise
until it is hooked to the flange, and then secure it permanently with the M3 metric screw
provided.
- Power the hood in accordance with applicable regulations (see sect. D of this booklet).
HOOD INSTALLATION WITH GLASS (OPTIONAL) (fig. O6-07-08-09-10)
- Remove the metal filter using handle (M). Disconnect the hood from the mains.
- Disconnect the connector (S) of the spotlights cable.
- Remove the body (A) from the chimney and extension (B+D) unit, loosening the 4 M4 milled
metric screws (V3).
- Slightly loosen the centring and anti-rotation metric screws (V4) in the lower flange of the
cone (B), then centre the glass slots with the metric screws.
- Fasten the body (A) to the chimney and extension unit (B+D) with the 4 M4 milled metric
screws (V3) provided.
- Reconnect connector (S).
- Refit the metal filter using the handle (M). Supply power in accordance with applicable
regulations (see sec. D of this booklet).
WALL HOOD
Fig. W01-W02