Specifications

26
until it is hooked to the flange, then fasten permanently with the M3 metric screw provided.
- Power the hood in accordance with applicable regulations (see sect. D of this booklet).
WALL HOOD
Fig. W01-W02
- Locate the desired height between the hood and the bob (see sect. C).
- Remove the back (A) by removing the cover caps (T) and loosen the inside fastening screws
(V1).
- Mark the 4 drilling points F, according to the dimensional specifications shown in the figure,
or use the back as a drilling template.
Fig. W03-W04
- Fasten the back (A) to the wall using the 4, 8 mm Ø expansion plugs, and the screws (V2)
provided.
- The horizontal and vertical alignment of the back with a spirit level.
Fig. W05-W06
- For the exhaust version, (define the upper and lower output use) locate the optimal length
of the fumes exhaust pipe (F) and connect. To facilitate the operation, if the ceiling height
allows it, cover B can be temporarily removed by acting on fastening screws. Carry out elec-
trical connections only after disconnecting the power supply. For the filter version, make
sure the exhaust on cover B is free to allow the air purified by carbon filters to be exhausted.
- Attach the hood to the back using the 4 hooks (G) ensuring the hood is down by approx 10
mm, to check its tightness.
Fig. W07-W08
- Tighten, but not completely, the two upper fastening screws (V1).
- Lift the hood to the desired position and tighten the upper and lower fastening screws com-
pletely (V1).
- Power the hood in accordance with applicable regulations (see sect. D of this booklet).