User's Instructions

11
Car Find Function
When using the remote control to carry
out car find operations, the hazard
warning lights will flash twice and the
horn will sound twice to allow you to
confirm the location of the vehicle. This
function is useful for finding your
vehicle in places such as large car
parks.
Answer Back Function
This device conducts bidirectional
communication between the remote
control and the controller (vehicle side).
The user can check the status of the
operations: engine start, engine stop,
warm up time, and car find using the
LED on the remote control.
Remote control
Directions for car find
operation → P.19
1. The reference operating range of the remote control is approx. 2000ft (610m).
However, this range can be reduced by interference caused by any of
conditions as follows.
 There is any obstruction nearby (Buildings, walls, other vehicles, etc.).
 There is any radio wave transmission nearby (television, radio, cellular,
another remote controller, etc.)
 The battery becomes weak.
2. When there is a signal being transmitted that is close to the frequency band
used by this device in the surrounding area, transmission between the remote
control and controller shall be restricted. In this situation, the remote control
will display a communication error.
3. When conducting consecutive operations with the remote control switches,
wait until after the LED turns off.
4. A receive error may display on the remote control even if the engine has
started, depending on the radio transmission conditions in the area.
Note
Car find
Answer back
Send
Vehicle side
(
Controller
)