User's Instructions

12
7. Low battery warning & replacement directions
If the battery power is depleted, the LED light (red) turns on when a switch is
pressed and battery power depleted is indicated. In this case, as battery
replacement will be required soon, replace the batteries with new ones
according to the following procedure.
 Keep the batteries out of the reach of children. In the event that a battery is
accidently swallowed, consult with a physician right away.
 Do not peel off the tape which is attached to the backside of the battery cover.
WARNING
Remove the battery packing.
Tap the remote control with the palm of
your hand to remove the batteries.
Install the new batteries with the (+) poles
facing upwards and attach the battery
packing and the battery cover.
Cellophane tape
Push down
Push down the inserted screwdriver and
remove the battery cover.
Insert the minus precision screwdriver into
the hollow in the end.
Attach cellophane tape or similar as shown
in the diagram to prevent the remote
controller from becoming scratched.
Be sure to insert the
plus (+) side facing upward
When replacing the lithium batteries (CR2032), replace both batteries together.
ADVICE
Battery packing
Hole
Minus precision screwdrive
r
Align the direction of the tab
with the mark on the case.
Tab