User's Manual

ManualsBrandsFALTEC ManualsElectronicsRemote Transmitter

- 1 -

Remote Control Engine Starter System

Owner’s Manual

Congratulations on your purchase of the MITSUBISHI MOTORS Remote Control Engine

Starter System. This system will provide you with convenience and assistance, making

each drive a delightful experience.

To take full advantage of your MITSUBISHI MOTORS Remote Control Engine Starter System

please read this manual thoroughly.

Keep this manual handy for easy reference.

１．Introduction・・・・・・・・・・・・・・・・・・・・・・・・・・２

２．Features of the System ・・・・・・・・・・・・・・・・・・・・・３

３．Safety Precaution・・・・・・・・・・・・・・・・・・・・・・・・４

４．Operating the Transmitter・・・・・・・・・・・・・・・・・・・・６

５．Setting the Idling Time・・・・・・・・・・・・・・・・・・・・・８

６．Before Leaving Your Car・・・・・・・・・・・・・・・・・・・・・８

７．Care and handling・・・・・・・・・・・・・・・・・・・・・・・・９

８．Transmitter Battery Replacement・・・・・・・・・・・・・・・・１０

９．Troubleshooting・・・・・・・・・・・・・・・・・・・・・・・・１１

１０．Specifications・・・・・・・・・・・・・・・・・・・・・・・１２

MITSUBISHI MOTORS Remote Control Engine Starter System is only for Automatic

transmission cars.

DO NOT install MITSUBISHI MOTORS Remote Control Engine Starter System in Manual

transmission cars.

DANGER

！

08, 8

Introduction

Summary of content (12 pages)

PAGE 1
Remote Control Engine Starter System Owner’s Manual Introduction １．Introduction・・・・・・・・・・・・・・・・・・・・・・・・・・２２．Features of the System ・・・・・・・・・・・・・・・・・・・・・３３．Safety Precaution・・・・・・・・・・・・・・・・・・・・・・・・４４．Operating the Transmitter・・・・・・・・・・・・・・・・・・・・６５．Setting the Idling Time・・・・・・・・・・・・・・・・・・・・・８６．Before Leaving Your Car・・・・・・・・・・・・・・・・・・・・・８７．Care and handling・・・・・・・・・・・・・・・・・・・・・・・・９８．Transmitter Battery Replacement・・・・・・・・・・・・・・・・１０９．Troubleshooting・・・・・・・・・・・・・・・・・・・・・・・・１１１０．Specifications・・・・・・・・
PAGE 2
１．Introduction Safety Messages ●The following symbols are used in this manual. ！ DANGER ！ WARNING are extremely important. The instructions following these symbols must be read thoroughly and followed accordingly. ！ DANGER The instructions following this symbol must be followed for safety. Failure to do so will result in death or serious injury. ！ WARNING The instructions following this symbol must be followed for safety. Failure to do so can result in injury and/or property damage.
PAGE 3
２．Features of the System ●The remote control engine starter system consists of a Transmitter that allows you to start and stop the engine from outside of the vehicle without using the car keys. ← P.6 However, as precaution measures, the Transmitter will not start the engine unless all of the following conditions are satisfied: ①The gearshift lever is in the “P" (Parking) position. ② All the doors are closed securely.（cars may include tail gates and spare tire carriers, depending on a model.
PAGE 4
３．Safety Precaution ！ DANGER Do not start your engine in a closed garage or other area with poor ventilation. Exhaust fumes can cause poisoning and cause unconsciousness and even death. ！ DANGER Electric waves from the transmitter can carry very far depending on the surrounding circumstances. Do not operate the switches on the transmitter unnecessarily.
PAGE 5
！ WARNING Do not start the engine near flammable material, such as grass. It can cause fire. ！ WARNING Do not start the engine without removing the body cover from the car. It can cause fire. ！ WARNING To prevent accidents during engine warm up, when parking make sure that: - the wiper switch and winkers are turned OFF. Wipers moving when the engine is started may be dangerous. The motor may be damaged if the wiper has frozen. - windows are closed. - doors are locked.
PAGE 6
４．Operating the Transmitter Electric waves from the transmitter can carry very far depending on the surrounding circumstances. To prevent an accident caused by accidental start of the engine, be sure to operate the remote control car starter system in an area where you can check the surroundings of your car. Before you start the engine ・Check your car so that it satisfies all conditions listed on page 8. Starting the engine. Operation of the Transmitter 1 Push the request button.
PAGE 7
Stopping the engine. Operation of the Transmitter 1 Push the request button 2 Let go of the request button when the indicator blinks. 3 Push the stop button while the indicator is blinking (about 2 seconds). REQ The blinking indicator will change to a continuous light (about 3 seconds), and the engine-stopping signal will be transmitted 4 The engine stops.
PAGE 8
５．Setting the idling time Consult your dealer for setting the idling time. The idling time can be set for 5 minutes, 10 minutes, 20 minutes or 30 minutes. Initial setting (at factory before shipping) is ten minutes. ６．Before Leaving Your Car Always confirm that the following engine starting conditions 1-4 are satisfied before using the remote control engine starter. As a precaution measure, the engine will not start if any one of the conditions 1-4 is not satisfied.
PAGE 9
７．Care and handling To prevent system breakdown and accidents ！ WARNING ・tore the transmitter out of reach of children If your transmitter is ever lost or malfunctioning, contact your dealer at once. ・ In case you lend your car and keys to a third party, do not include your Transmitter for preventing accidents. ●Do not leave the Transmitter in places of high temperature (60℃ or more) such as the dashboard etc. ●Do not drop, throw, or step on the Transmitter.
PAGE 10
８．Transmitter Battery Replacement Replace old batteries for new ones according to the following procedures: Battery Replacement 1 ① Remove the screw in the battery cover using a plus driver. ② Lift the front side of the cover. ③ Remove the cover. Be careful of the tab. ① 3 Close the battery cover according to steps ① to ③. ③ ③ ② ② ① 2 Insert two new batteries (coin type lithium batteries CR2032×2) with the positive (+) mark facing upward.
PAGE 11
９．Troubleshooting Check the following symptoms to diagnose problems with the Remote Control Engine Starter System before consulting your dealer. Engine does not start by operating the transmitter. 【The indicator of the Transmitter does not light up】 Check Remedy Is a transmission repeated directly one after another? Is the battery correctly set? Are the batteries discharged? The next transmission cannot be made for two seconds after the indicator goes off.
PAGE 12
１０．Specifications Main Unit(Receiver) Transmitter Communication Communication 426.0500MHz frequency frequency Communication uni-directional Communication method (transmission.) method Application standard Transmission time Transmission Transmission FCC conforming rest time antenna power-supply Two seconds or more batteries Battery life consumption at Size of case 130.0*×93.0*×28.