User's Manual
12
Car Find Function
If the car find operation is
performed on the remote control,
the hazard lights will flash twice and
the horn will sound twice so you
can confirm the vehicles location.
This function is convenient when
looking for your vehicle in a large
parking lot, etc.
Answer Back Function
This device conducts bidirectional
communication between the remote
control and the controller (vehicle
side). The user can check the status
of the operations: engine start,
engine stop, warm up time, internal
vehicle temperature and rear defrost,
using the LCD monitor on the
remote control.
Radio Act Regulations
1. When there is a signal being transmitted that is close to the frequency band used
by this device in the surrounding area, transmission between the remote control
and controller shall be restricted due to the regulations imposed by the Radio Act.
In this situation, the remote control will display a send error and/or a receive error.
2. When conducting consecutive operations with the remote control switches, wait
2 seconds or longer after the Send mark on the LCD monitor has turned off,
and then perform the next operation. The operation signal will not be received i
f
the second operation is performed within 2 seconds of the first. Consecutive
transmission signals that occur within 2 seconds of each other are restricted
according to the Radio Act.
3. If a send error is displayed, the radio transmission in the area is restricted. Wait
until the display mark turns off before operating the remote control.
4. Regardless if a receive error displays, the engine may have started. (After the
controller receives a signal from the remote control, the controller may not be able
to successfully send an answer back signal to the remote control due to the radio
transmission conditions in the area.)
Note
Answer back
Send
Remote control
Vehicle side
(
Controller
)
Car find