User's Manual

21
9-4. Vehicle status check
This operation can be performed before or after the engine start operation.
1) Press the function switch until it
beeps.
The LCD display will appear as shown
on the right.
After the send mark flashes, the send
operation is completed. After the send
operation is completed, the controller
will send an answer back signal.
When the remote control receives a
response from the vehicle, it indicates
the engine start operation with a
display (on the right) and a melody.
The following 2 items can be checked.
Is the engine running?
Is the rear defrost turned on?
The temperature display is only a guide.
The actual temperature may vary
depending on the vehicle parking
conditions. Some vehicle models stop
the rear defrost after 15 minutes. (*In
this situation, the condition error will not
display.)
Not
e
Function switch
Display Reference Example
Engine running Engine stopped
Displays
when engine
starts
Displays
when engine
stops
Displays when
rear defrost is
turned on