User Manual

19
ESC instruction
The electronic speed controller can be connected to the motor by soldering directly, or with high quality
connectors.
Always use new connectors, which should be soldered carefully to the cables and insulated with heat
shrink tubes.
The maximum length of the battery pack wires should be within 6 inches.
Motor
Brushless Speed Controller
ESC
Brushless Controller
A quality connector
is essential
Battery
Pack
Receiver
Solder controller to the motor wires.
Solder appropriate connectors to the battery wires.
Insulate all solder connectors with heat shrink tubes.
Plug the “JR” connector into the receiver throttle channel.
Speed Controller Red and Black wires connect to battery pack Red and Black wires respectively.
Wires Connection:
Features:
◆ Extremely low internal resistance
◆ Super smooth and accurate throttle linearity
◆ Safety thermal over-load protection
◆ Auto throttle shut down in signal loss situation
◆ Supports high RPM motors
◆ Power arming protection (prevents the motor from accidentally running when switched ON)
◆ New advanced programming software