User Manual

5
fig5
fig3
fig2
1.
Slide both wing tubes into the wing holes. Both tube are the same length. Ensure the connector wires pass
through the hole to the top side of the wing. Secure the wing together by installing two brackets where the
two wing halves join as shown.
2.
Unpack the elevator parts bag and assemble using screw PA2.6*40mm, attach the Z-bend end of the control
rod to the servo arm’s center hole. Attach the linkage on the control horn. See the control horn and servo arm
settings on page 9.
3.
Assemble the Vertical Tail to the fuselage using the screw PA2.6*40mm at the front and PA2.6*30mm at the
rear. Attach the Z-bend end of the control rod to the servo arm’s hole. Attach the linkage on the control horn.
See the control horn and servo arm settings on page 9.
Assemble the plane
fig6
fig1
PA2.6*40mm
fig4
PA2.6*40mm
PA2.6*30mm