User Manual

fig8

Install the battery

fig9

Gear

1. Lower the throttle and throttle trim to the lowest setting. Power on the Transmitter, then wait 4 seconds. It

is recommended to apply hook and loop tape to the bottom of your battery.

2. Install the fully charged battery in the battery compartment as shown. See the Adjusting the Center of

Gravity instructions for more information.

Attach the aileron servo leads to the previously installed "Y" harness. Elevator servo lead goes to elevator

channel of your receiver. The rudder servo goes to the rudder channel. Attach the ESC connector to the

throttle channel of the receiver. Connect the LED to any spare channel of your receiver. If using just a 6

channel receiver you can attach a "Y" harness to any of the channels and plug in the LED lead.The LED to

any spare channel. Tuck the wire leads into the recessed cavity at the rear end of the battery hatch.

fig7

Turn over the fuselage so the bottom faces up and feed the connector wires through the hole in the

fuselage. Secure the wing in place using 4 wing screws.

Flap

HKM3.0*65mm

ESC

BATT