Use and Care Guide

8
How to Assemble Your Ceiling Fan (continued)
9. Cut off excess lead wire approximately 6 to 9 inches
above top of the top of the downrod. Strip insulation off
1/2 inch from the end of each lead wire. (Figure 9)
Figure 8
Figure 9
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
8. Reinstall the hanger ball on the downrod as follows.
7. Route wires through canopy screw cover and ceiling
canopy. (Figure 7)
Route the black, white and blue wires through the
hanger ball. Position the pin through the two holes in
the downrod and align the hanger ball so the pin is
captured in the groove in the top of the hanger ball.
Pull the hanger ball up tight against the pin. Securely
tighten the set screw in the hanger ball. A loose set
screw could create fan wobble. (Figure 8)
Figure 7
Ceiling Canopy
Canopy Screw
Cover
Motor Coupling
Cover
Motor
Assembly
Figure 6
6. Route wires through motor coupling cover and use
the two screws removed in the previous step to attach
motor coupling cover to the motor assembly. (Figure 6)