Installation Guide

11
How to Install Your Canopy Housing
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
NOTE: This step is applicable after the neccessary wiring is completed.
Canopy Screw
Cover
How to Assemble Your Ceiling Fan Blades
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
NOTE: Periodically check blade holder hardware and
resecure if necessary.
2. Secure the blade holders to the hub of motor
DVVHPEO\XVLQJWKHÝVFUHZV)LJXUH
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
x 27
3/16Ŋ-24
Pan Head
Serrated Screw
HARDWARE USED:
Figure 2
Ceiling Canopy
Figure 1
3/16 -24 Pan Head
Serrated Screw
(3 each per blade)
Blade
Blade Cover
Blade Holder
Figure 1
1. Lay the blade holders with the threaded posts and
pitched foot facing up. Position the blades over the
blade holders with the threaded posts showing. Make
sure the bottom edge of the blades is fully seated
against the blade holders. Place blade covers on top
of the blades, positioning the holes over the threaded
posts. Tighten pan-head screws to secure the blades
to the blade holders. (Figure 1)
HARDWARE USED:
x 27
1/4Ŋ-20
Pan Head
Screw
Figure 2
1/4 
Pan Head Screw
(3 per assembly)