Installation Guide

How to Assemble the Light Kit Assembly or Cap

1. Remove one of the three screws in the support bracket

at the bottom of the motor assembly. Retain the screw

for later and slightly loosen the remaining two screws.

(Figure 1)

2. Assemble the light kit to the support bracket using

the two key slots in the light kit. Replace the previously

removed screw and securely tighten all three screws.

(Figure 2)

3. Remove one of the three screws in the light kit.

Retain the screw for later and slightly loosen the

remaining two screws. (Figure 3)

Motor

Assembly

Screws (3)

LED

Assembly

Figure 1

Figure 2

Figure 3

Light Kit

Light Kit Wire Cover

Figure 4

4. If installing the light kit, skip this step.

Assemble the light kit wire cover to the light kit using

the two key slots. Replace the removed screw and

secure all three screws. (Figure 4)

Connect the 2 single pin connectors from the LED

assembly to the 2 single pin connectors from motor

assembly. (Figure 5A)

To reduce the risk of electric shock, disconnect the

electrical supply circult to the fan before installing

light kit.

CAUTION

5A. For use with light kit.

Figure 5A Figure 5B

Steel Cap

5B. For use with steel cap.

If you want to install the steel cap and not the light kit.

Assemble the steel cap to the light kit by twisting in

a clockwise direction. (Figure 5B)

NOTE:

If you have installed your fan with the steel

cap, skip Steps 6 and 7.