Use and Care Guide

10
How to Assemble the Light Kit Assembly or Cap (continued)
7. Secure the glass to light plate assembly by twisting
in a clockwise direction. Do not over-tighten. (Figure 7)
Glass
LED Assembly
Figure 7
Figure 6
How to Operate Your Ceiling Fan
1. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 1)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
MAIN FUSE BOX
Figure 1
0: Power Off
1: Low Speed
2: Medium Speed
3: High Speed
Light Switch:
Fan Speed Switch:
0: POWER OFF,
Turn switch counterclockwise to increase
light and clockwise to dim it.
Figure 2
2. Wall control functiolns: (Figure 2)
Light Kit
6. Assemble the LED assembly to the light kit using
the two key slots. Replace the removed screw from
Step 3 and secure all three screws. (Figure 6)
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
CAUTION