AIRE DÉCOR Ceiling Fan INSTALLATION INSTRUCTIONS Model Series BP210**1 BP215**1 BP220**1 BP225**1 READ AND SAVE THESE INSTRUCTIONS
3. SAFETY RULES 1. TOOLS AND MATERIALS REQUIRED Philips screw driver 1. To reduce the risk of electric shock, insure electricity has been turned off at the circuit breaker or fuse box before beginning. 2. All wiring must be in accordance with the National Electrical Code and local electrical codes. Electrical installation should be performed by a qualified licensed electrician. Blade screw driver 11 mm wrench Step ladder Wire cutters 3. 2. PACKAGE CONTENTS 4. Unpack your fan and check the contents.
4. MOUNTING OPTIONS 5. HANGING THE FAN If there isn't an existing UL listed mounting box, then read the following instructions. Disconnect the power by removing fuses or turning off circuit breakers. REMEMBER to turn off the power. Follow the steps below to hang your fan properly. NOTE: This ceiling fan is supplied with two types of hanging assemblies; the standard ceiling installation using the downrod with ball and socket mounting and the "close-to-ceiling" installation.
CLOSE-TO-CEILING INSTALLATION Step 6. Slip canopy onto downrod. Carefully reinstall hanger ball onto rod being sure that cross pin is in correct position, the set screw on hanger ball is tight and wires are not twisted. (Fig. 8) 1. Remove the decorative canopy bottom cover from the canopy. (Fig. 10) Downrod Step 7. Now lift the motor assembly into position and place the hanger ball into the hanger bracket. Rotate until the "Check Tab" has dropped into the "Registration Slot" and seats firmly. (Fig. 9).
6. MAKE THE ELECTRIC CONNECTIONS POWER LINES 120V Remember to disconnect the power. Follow the steps below to connect the fan to your household wiring. Use the wire connecting nuts supplied with your fan. Secure the connectors with electrical tape. Make sure there are no loose strands or connections. WH BLK GREEN GROUND Step 1 Connect the fan supply (black) wire and light supply (blue) wire to the black household supply wire as shown in Figure 13.
10. INSTALLING THE LIGHT BULBS AND GLASS SHADES 8. ATTACHING THE FAN BLADES Caution: Remove 5 rubber packing mounts and discard before installation. (OPTIONAL) Step 1 Attach the blade to the blade bracket using the screws and fiber washers as shown in Figure 18. Start screw into bracket. Repeat for the two remaining screws. Step 2 Tighten each screw. Make sure the blade is straight. Screws Fiber washers Step 3 Fasten blade assembly to motor using the screws supplied. (Fig.
13. TROUBLESHOOTING 11. OPERATING YOUR FAN Turn on the power and check the operation of your fan. The pull chain controls the fan speed as follows: Problem Solution Fan will not start. 1. Check circuit fuses or breakers. 2. Check line wire connections to the fan and switch wire connections in the switch housing. CAUTION: Make sure main power is off. Figure 21 Fan sounds noisy. 1. Make sure all motor housing screws are snug. 2.