Installation Guide

5. Assemble the switch cover assembly onto the
support cover switch cup with three screws provided.
(Figure 5)
3. Remove one of the three screws in the support
bracket. Attach the switch cup support cover to the
support flange by rotating plate and properly positioning
screws in key slots. Install third screw in remaining hole.
Fully tighten all three screws. (Figure 3)
4. Securely attach 9-pin connector from motor
Figure 4
assembly to wiring harness socket within switch cover
assembly. (Figure 4)
WARNING
The color label on these two connectors must correspond
to each other.
Figure 5
Screw (3)
Figure 3
Mounting the Fan Blades and Cover Switch Cup Assembly (continued)
10
Maintenance
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to
avoid scratching the finish.
Abrasive cleaning agents are not required and should be
avoided to prevent damage to finish.
CAUTION
Do not use water when cleaning your ceiling fan. It
could damage the motor or the blades and create the
possibility of electrical shock.
Blade Cleaning
Periodic light dusting of the blades is recommended.
A feather duster will work best.
Avoid using water, cleansers, or harsh rags, which can
warp and ruin the blades.