Installation Guide

Installing the Canopy Housing

1. Remove one of the two shoulder screws in the

hanger bracket. Loosen the second shoulder screw

without fully removing it. Assemble canopy by

rotating key slot in canopy over shoulder screw in

hanger bracket. Tighten shoulder screw. Fully

assemble and tighten second shoulder screw that

was previously removed. (Figure 1a)

WARNING

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy

housing and not pinched between the housing and the

ceiling.

2. Securely attach and tighten the canopy screw cover

over the shoulder screws in the hanger bracket utilizing

the keyslot twist-lock feature. (Figrue 1b)

Figure 1a Figure 1b

Mounting the Fan Blades and Cover Switch Cup Assembly

INSTALLATION NOTE

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled may

result in damage to the fan blades.

2. Disassemble switch cup support cover from cover

switch cup assembly removing three screws. (Figure 2)

WARNING

To reduce the risk of personal injury, do not bend the

blades when installing, balancing or cleaning the fan.

Do not insert foreign objects in between the rotating

blades.

1. Securely fasten the three blades with phillips-head

Figure 1

Figure 2

Support Cover

Switch Cup

Blade Screws

screws with flat washers. (Figure 1)

Phillips-Head

Screw with

Flat Washer

(3 per blade)