Installation Guide

ManualsBrandsFanimation ManualsCeiling FansZonix Wet 52-in Matte White LED Indoor/Outdoor Ceiling Fan with Light Kit (3-Blade)

• Motor Assembly

• Downrod/Hanger Ball

Assembly

• Hanger Bracket

• Ceiling Canopy

• Canopy Screw Cover

• Motor Coupling Cover

• Switch Cup Cover Assembly

• Receiver Unit

• Hand-Held Remote

• Hardware bags:

– Ten 3/16˝-24 (blade to motor hub)

Serrated head screws & stainless

flat washers

– Four wire connectors

– Blade Balance Kit

– Two #8-32 junction box screws,

stainless steel

– Two Flat Washer, stainless steel

Unpacking Instructions

For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all

steps have been completed and will be helpful in ﬁ nding your place should you be interrupted.

Wiring outlet box and box connectors must be of type

required by local code. The minimum wire would be a 3-

conductor (2-wire with ground) of the following size:

NOTE: Place the parts from the loose parts bags in a small

container to keep them from being lost. If any parts are missing,

contact your local retailer.

Tools Needed for Assembly Materials

Wire Size A.W.G.Installed Wire Length

Up to 50 ft.

50 - 100 ft.

NOTE: If you are uncertain of part description, refer to

exploded view illustration.

1. Check to see that you have received the following

parts:

Switch Cup Cover

Assembly

(MA4660**)

Switch Cup Cover

Assembly

(MA4660SSBNW)

Hardware Bags

Motor Assembly

Downrod/

Hanger Ball

Assembly

Hanger Bracket

• One Phillips head screwdriver

• One stepladder

• One ¼˝ blade screwdriver

• One wire stripper

• One hex wrench

Ceiling Canopy

Motor Coupling Cover

▲

WARNING

Do not install or use fan if any part is damaged or

missing. This product is designed to use only those

parts supplied with this product and/or any accessories

designated specifically for use with this product by

Fanimation. Substitution of parts or accessories not

designated for use with this product by Fanimation could

result in personal injury or property damage. Contact

your retail store for missing or damaged parts.

▲

WARNING

Before assembling your ceiling fan, refer to section on

proper method of wiring your fan (page 10). If you feel you

do not have enough wiring knowledge or experience,

have your fan installed by a licensed electrician.

Canopy

Screw Cover

This manual is designed to make it as easy as possible for you

to assemble, install, operate, and maintain your ceiling fan

Hand-Held

Remote

Receiver Unit

– Bag Assembly Safety Cable