Installation Guide

Light Plate
Assembly
LED Assembly
Figure 5
2. Assemble the light plage assembly to the motor
assembly support bracket using the two key slots
in the light plate assembly. Replace the previously
removed screw and securely tighten all three screws.
(Figure 2)
5. Assemble the LED assembly to the light plate
assembly using the two key slots and replace the
third screw removed in Step 3 and securely tighten
all three screws. (Figure 5 )
How to Assemble the Light Kitn or Cap
10
Motor
Assembly
Light Plate Assembly
Figure 2
3. Remove one of the three screws in the light plate
the remaining two screws. (Figure 3)
assembly and retain the screw for later. Slightly loosen
Motor Assembly
4. For use with light kit
Connect the 2 single-pin connectors from the
LED assembly to the 2 single-pin connectors from
motor assembly. (Figure 4 )
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
CAUTION
1. Remove one of the three screws in the support
bracket at the bottom of the motor assembly and
retain the screw for later. Slightly loosen the
remaining two screws. (Figure 1)
To Reduce The Risk Of Electric Shock, Disconnect
The Electrical Supply Circuit To The Fan Before
Installing Light Kit.
CAUTION
NOTE: If you have installed your fan with the steel
cap, skip Steps 4, 5 and 6.
Figure 1
Light Plate
Assembly
Figure 3
LED Assembly
Motor
Assembly
Figure 4