Installation Guide

INSTALLATION NOTE

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled may

result in damage to the fan blades.

▲

WARNING

To reduce the risk of personal injury, do not bend the

blades when installing, balancing or cleaning the fan.

Do not insert foreign objects in between the rotating

blades.

x 9

FLAT WASHER

HARDWARE USED:

3/16˝-24

3/16˝-24 Serrated Head Screw

with Flat Washer (3 per blade)

Figure 1

1. Position blades over the threaded posts and secure

with the 3/16˝-24 serrated head screws and flat

washers. (Figure 1)

How to Assemble Your Ceiling Fan Blades

How to Assemble Your Light Kit

Motor Assembly

Figure 1

2. Assemble the light kit to the motor assembly

support bracket using the two key slots in the

light kit. Replace the previously removed screw and

securely tighten all three screws. (Figure 2)

3. Remove one of the three screws in the light kit

and retain the screw for later. Slightly loosen the

remaining two screws. (Figure 3)

1. Remove one of the three screws in the support

bracket at the bottom of the motor assembly and

retain the screw for later. Slightly loosen the

remaining two screws. (Figure 1)

To Reduce The Risk Of Electric Shock, Disconnect

The Electrical Supply Circuit To The Fan Before

Installing Light Kit.

CAUTION

Light Kit

Figure 3

Motor

Assembly

Light Kit

Figure 2

SERRATED HEAD

SCREWS