Specs

PUNKAH
®
FP720-Fan Unit / FP780-Motor
Ceiling Mount Assembly
Weights (Approximate)
Fan Assembly Unit 5 lbs
Motor Assembly Unit 17½ lbs
Ceiling Assembly Specifications
A Overall Length 4´ to 24´
B Support Spacing 12˝ to 4´ *
C Fan Base Unit 4½˝ L x 4½˝ W
D Overall Drop
23˝ with 18˝ Blades
27˝ with 22˝ Blades
E Blade Sweep
21˝ with 18˝ Blades
25½˝ with 22˝ Blades
F Motor Assembly Unit 13¾˝ L x 7¼˝ W
INSTALLATION REQUIREMENTS
It is recommended that each fan and motor have ¾˝ plywood backing (12˝ x 12˝ min.) fit snug
behind the sheet rock for adequate support. This may also be done with continuous backing
running the length of the fan system, allowing greater flexibility in blade placement.
ELECTRICAL REQUIREMENTS
A 120 VAC electrical feed is required and should be accessible to the
center of the motor. This circuit should be wired to an on/off switch
(Motor is single speed). The motor assembly is supplied with a 2 ft.
cord with plug. Motor assembly may be wired directly to electrical
outlet box. The Fan Blades oscillates at approximately 18-20 rpm.
C
B
A
E
C
*For spacing of 12˝ to 27½˝, cutting of push rods is required.
NOTES:
Installation is NOT recommended for sound sensitive areas.
Not designed for significant air movement.
Not recommended for Damp Location.
77