Installation Guide

For illustrative purposes only-not
intended to cover all types of controls
How to Operate Your Remote Control
1. IMPORTANT: Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
MAIN FUSE BOX
Figure 2
Figure 1
11
Figure 3
REMOTE
3V, CR2032
BATTERY
(2 PCS)
CONTROL
ECE
2. Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
• HI Push Button – high fan speed
• MED Push Button – medium fan speed
• LOW Push Button – low fan speed
• REV Push Button – toggles airflow direction
• Push Button – fan off
• Light Push Button – on/off, hold for infinite light level
3. Operating & Using Hand-held Remote (Figure 3):
Install two piece of 3 volt battery (If not using for long
periods of time, remove battery to prevent damage to
Store hand-held remote). the hand-held remote away
from excess heat or humidity.