User Manual

9
Figure 20
HARDWARE USED:
x 10
#10-32 x 3/8Ŋ
SCREWS
NOTE: Periodically check blade holder hardware and
resecure if necessary.
4. Secure the blade holders to the flywheel using the
#10-32 x 3/8ÝVFUHZVWKURXJKWKHKROHVORFDWHGRQWKH
bottom of the flywheel. (Figure 20)
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
Blade Holder
Flywheel
Adapter-Switch
housing
Motor
Assembly
#10-32 x 3/8Ý Screws
(2 per assembly)
Figure 21
5. Remove one of the three screws in the motor
assembly. Slightly loosen the remaining two screws.
Assemble the adapter-switch housing to the motor
assembly using the two key slots. Replace the third
screw and securely tighten all three screws.
(Figure 21)
7. Remove one of the three screws in the adapter-
switch housing. Slightly loosen the remaining two
screws. Assemble the light kit assembly to the
adapter-switch housing using the two key slots.
Replace the third screw and securely tighten all three
screws. (Figure 23)
6. Securely attach the 4-pin switch cup connector
to the wiring harness switch housing within the
light kit assembly. (Figure 22)
Figure 23
Light Kit
Assembly
How to Assemble the Blades and Light Plate Assembly(continued)
Adapter-Switch
housing
Figure 22