Installation Guide

WARNING: To avoid fire, shock and serious personal injury, follow these instructions.
1. Unplug the USB port before maintenance and when the fan is not being used.
2. Do not touch the fan and/or USB port if your hands are wet.
3. Unplug the fan by pulling on the plug instead of pulling the power cord.
4. Do not use the fan if the power cord or the USB port is damaged, or if the power socket is loose.
5. Do not attempt to repair the cord yourself when there is damage. Do not add duplicated wire or
power cord.
6. Do not use the fan near any of the following: gas stove, any fire source, high humidity or high
temperature, oil soot with a lot of metal powder, obstacles affecting oscillating motion, or outdoors.
7. Do not insert hands or fingers into the fan guard, or the movable parts.
8. Do not use the fan with any solid-state speed control device to reduce the risk of fire or electric
shock.
9. Place the fan on a smooth and horizontal surface.
10. Those who are not qualified electricians should not dissemble, repair or rebuild the fan.
11. If the power cord is damaged, it must be replaced by supplier, authorized service agent or
qualified electrician to avoid danger.
12. This fan should be used by, or under the direct supervision of, a responsible adult.
13. Supervise children around the fan when it is plugged in. This type of fan may facinate children,
but they should not be allowed to play with it.
CAUTION: Before connecting your fan, ensure the voltage indicated on the rating plate
corresponds to the electrical main voltage of your home. Plug the power cord into a suitable
socket.
FP7988MB USB FAN Operating Instructions
READ AND SAVE THESE INSTRUCTIONS
Weight: 0.47 lbs (0.22 kgs)
Operating Instructions
• Slide Switch position 2 – high fan speed
• Slide Switch position 1 – low fan speed
• Slide Switch position OFF – fan off
OFF
1
2
POWER SOURCE
FAN SPEED SWITCH
Select the desired airflow, located on the fan base by
the slide switch.
1. USB powered: Plug the USB power cord into a PC or
laptop USB connector.
2. Main power socket: Plug the USB power cord into A/C
adaptor, then plug into a suitable main power socket.
Slide Switch

Summary of content (4 pages)