Installation Guide
3
Fan Motor Assembly•
Switch Cup/Adapter •
Assembly
Light Kit Assembly •
Cover-Switch Cup Assembly
(FP8012**)
•
(FP8016**)
Hanger Bracket Assembly•
Downrod/Hanger Ball •
Assembly
Ceiling Canopy•
Canopy Screw Cover Assembly•
Motor Coupling Cover Assembly•
Blade Holder Set•
Blade Set•
Glass Bowl (FP8016** only)•
100 watt minican bulb (FP8016** only)•
Hardware bags:•
–
-20 x 14 mm screws with lock
washers (blade holder to fan motor hub)
–
-24 x 7.5 mm washer-head screws
(blade to blade holder)
– Fiber washers
– Phillips screwdriver, 4˝
– Four wire connectors
– Chain fob/coupler
– Balance Kit
– Pull Chain Kit -ligth
(FP8016** only)
– Pull Chain Kit -fan
Fan Motor Assembly
Adapter Switch Cup
)**2108PF( ylbmessA
Adapter Switch Cup
)**6108PF( ylbmessA
Cover-Switch Cup
Assembly (FP8012**)
Light Kit Assembly
(FP80016**)
Hanger Bracket
Assembly
Downrod/Hanger
Ball Assembly
Ceiling Canopy
Canopy Screw Cover
Motor Coupling Cover
Blade Holders Set
Blade Set
Glass Bowl
(FP8016**)
100-Watt
Minican Bulb
(FP8016**)
Hardware Bag
Assembly
Assembly
–
–
#8-32x19 mm Junction box screws
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 11)
1. Check to see that you have received the following
parts:
▲
WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
Unpacking Instructions
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in fi nding your place should you be interrupted.
This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
Tools Needed for Assembly Materials
Wire Size A.W.G.Installed Wire Length
14
12
Up to 50 ft.
50 - 100 ft.
• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
• One wire stripper
• Four wire connectors
(supplied)
▲
WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
Flat Washer Ø12 x Ø5 x1 mm,
Stainless Steel (2)