Installation Guide

Assembling Fan With the Light Kit

1. Disassemble the adapter switch cup assembly from

the switch cup support plate by removing three

screws. (Figure 1)

2. Disassemble the finial, trim cover and nut from

adapter switch cup assembly. (Figure 2)

3. Connect the 2 single pin connector from motor

assembly to the 2 single pin connector from the

adapter switch cup assembly. (Figure 4)

Figure 4

Figure 1

Figure 2

Figure 3

2. Remove one of the three screws in the support

bracket at the bottom of the motor assembly.

Slightly loosen the remaining two screws. Assemble

the switch cup support plate to the support bracket

using the two key slots in the socket plate. Replace

the third screw and securely tighten all three screws

(Figure 3).

Switch cup support

plate

Adapter Switch cup

assembly

Adapter Switch cup

assembly

Adapter Switch cup

assembly

NOTE:

If you are assembling your fan without the light kit, please skip to page 15 of this manual.

To reduce the risk of electric shock, disconnect the

electrical supply circuit to the fan before installing

light kit.

CAUTION

Switch cup

support plate

Motor

Assembly

Finial

Trim Cover

Nut