Installation Guide

Cover Switch
cup
4. .puchctiwsrevocehtotniwercsehtnethgiT
(Figure 4)
Figure 4
5. delbmessaehtotnopuchctiwsrevocehtelbmessA
switch cup support plate with three screws.
(Figure 5)
Figure 5
x 1ß
PHILLIPS SCREW
HARDWARE USED:
Cover Switch
cup
15
Assembling Fan Without the Light Kit
1. Disassemble the adapter/switch cup assembly from
the switch cup support plate by removing three
screws. (Figure 1)
3. Remove the hex nut and spring washer from the
adapter/switch cup assembly. (Figrue 3)
2. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws. Assemble
the switch cup support plate to the support bracket
using the two key slots in the socket plate. Replace
the third screw and securely tighten all three screws.
(Figure 2)
Figure 1
Switch cup support
plate
Adapter/Switch cup
assembly
Adapter Switch cup
assembly
Figure 3
Figure 2
Switch cup
support plate
Spring Washer
Hex Nut