Installation Guide

Assembling Fan With the Light Kit
13
1. Disassemble the adapter/switch cup assembly from
the switch cup support plate by removing three
screws. (Figure 21)
3. Connect the 2-pin connector from motor assembly
4. otno ylbmessa puc hctiws/retpada eht elbmessA
the assembled switch cup support plate with three
screws. (Figure 24)
to the 2-pin connector from the adapter/switch cup
assembly. (Figure 23)
Figure 23
Figure 21
Figure 22
2. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws. Assemble
the switch cup support plate to the support bracket
using the two key slots in the socket plate. Replace
the third screw and securely tighten all three screws
(Figure 22).
Figure 24
Switch cup support
plate
Switch cup
support plate
Adapter/Switch cup
assembly
NOTE:
If you are assembling your fan without the light kit, please skip to page 14 of this manual.
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
light kit.
CAUTION