Installation Guide

Figure 1

Motor

Assembly

2. Assemble the switch housing assembly to the

adaptor plate of the motor assembly using the two

key slots in the switch housing assembly. Replace

the third screw and secure all three screws.

(Figure 2)

3. Remove one of the three screws in the switch

housing assembly. Retain the screw for later and

slightly loosen the remaining two screws. (Figure 3)

4. Securely attach 9-pin connector from motor

assembly to wiring harness socket within light plate

assembly. (Figure 4)

5. Assemble the light plate assembly to the switch

housing assembly using the two key slots in the light

plate assembly. Replace the third screw and secure

all three screws. (Figure 5)

How to Assemble Your Light Kit or Cap

1. Remove one of the three screws in the support

bracket at the bottom of the motor assembly. Retain

the screw for later and slightly loosen the remaining

two screws. (Figure 1)

Figure 2

Motor Assembly

Light Plate

Assembly

Switch Housing

Assembly

Figure 3

Figure 4

Figure 5

Switch Housing

Assembly

Switch Housing

Assembly

Light Plate

Assembly

WARNING

The color label on these two connectors must

correspond to each other.