Owner's Manual

11
How to Install Your Canopy Housing
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figrue 2)
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
NOTE: This step is applicable after the neccessary wiring is completed.
Canopy Screw
Cover
How to Assemble the Ceiling Fan Blades
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
HARDWARE USED:
x 18
1/4Ŋ-20
Pan Head
Screw
NOTE: Periodically check blade holder hardware and
resecure if necessary.
2. Secure the blade holders to the flywheel using the
1/4Ý-20 screws, the post on the blade holder need to
align the hole between the 1/4”-20 threaded holes
located on the bottom of the flywheel (Figure 2)
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
WARNING
!
To reduce the risk of electric shock, disconnect the
electrical supply circult to the fan before installing
light kit.
CAUTION
x 27
3/16Ŋ-24
Pan Head
Serrated Screw
HARDWARE USED:
1. Lay flat side of blade holder on a flat surface with the
inside of the blade holder arm facing up. This is the side
with the threaded posts and pitched foot. Position the
blade over the blade holder with the threaded posts
showing. Make sure the bottom edge of the blade is fully
seated against the blade holder. Place blade cover
on top of the blade, positioning the holes over the
threaded posts. With a Phillips screwdriver, thread three
screws into the posts but do not fully tighten.Prior to final
tightening, position the centerline of the blade holder
with the center of the end of the blade. Tighten three
screws to secure the blade. (Figure 1)
Figure 2
Ceiling Canopy
Figure 1
3/16 -24 Pan Head
Serrated Screw (3 each per blade)
Blade
Blade Cover
Blade Holder
Figure 1
Figure 2
Blade Holder
1/4
-20
Pan Head Screw
(2 per assembly)